Minelab Gold Monster 1000 Metal Detector
Up until now, there has always been a compromise between frequency and sensitivity when optimizing detector performance, because lower frequencies are more sensitive to larger gold nuggets and higher frequencies are more sensitive to smaller gold nuggets.
When comparing detectors, the three curves in the diagram represent each detector’s ability to find small gold nuggets of a certain size, at a maximum possible depth. Most detectors will find a very large nugget just beneath the surface, however a detector’s sensitivity to gold determines how many smaller nuggets will ultimately be recovered in difficult (noisy) ground at greater depths.
An 18 kHz detector will normally have a depth advantage on nuggets ≥ 1.0g over a basic mid-frequency detector, and a 71 kHz detector will have a depth advantage on nuggets ≤ 0.1g. The advanced GOLD MONSTER 1000 uses an intermediate 45 kHz frequency AND a high speed 24-bit signal processor. This primary combination greatly boosts sensitivity to gold beyond that of other single frequency VLF detectors over a wide range of nugget sizes, without introducing excess noise and false signals.
The GOLD MONSTER 1000 also has improved ferrous/non-ferrous discrimination and copes better with conductive (salty) soils than higher frequency detectors, making it the perfect choice to maximize your gold recovery!
- Fully automatic operation
- Extra sensitive 45 kHz VLF performance
- Highly adaptable
- Wide ground coverage
- Confined-space detecting
- 2 search coils included
- Easy quick start
Factory Included Accessories:
- 110V NiHM Wall Charger
- Ni-MH Rechargeable Battery System
- 10" GoldSearch 1000 Elliptical DD Search Coil
- Blue Alkaline Battery Pack (Sovereign GT / Eureka Gold)